Titanium tunnel in a stretched earlobe
Alle gidsen

Sizing

Size chart: gauge to millimetres

Gauge measures jewellery thickness: the lower the number, the thicker the piece. 14g is 1.6 mm, 0g is 8 mm, 00g is 10 mm. Above 10 mm sizes are given in millimetres or inches.

GaugeMillimetresInches
20g0,8 mm1/32"
18g1,0 mm—
16g1,2 mm3/64"
14g1,6 mm1/16"
12g2,0 mm5/64"
10g2,5 mm3/32"
8g3,0 mm1/8"
6g4,0 mm5/32"
4g5,0 mm3/16"
2g6,0 mm1/4"
0g8,0 mm5/16"
00g10 mm3/8"
—12 mm1/2"
—14 mm9/16"
—16 mm5/8"
—19 mm3/4"
—22 mm7/8"
—25 mm1"

Thickness, length and diameter: don’t mix them up

Thickness is the section of the jewellery that passes through the hole. Length is the wearable part of a labret or barbell, between the two ends. Diameter, for rings and stretchers, is the size of the circle or of the plug face.

Why charts don’t always match

Gauge comes from an old wire system and manufacturers round differently: 10g may be listed as 2.4 or 2.5 mm, 8g as 3.0 or 3.2 mm. That’s why we always refer to the real size in millimetres at the studio.

How to measure the jewellery you wear

The most reliable way is a digital caliper, used on the jewellery and never on the open hole.

  • Measure thickness at the thinnest part of the bar, not on the ball.
  • For plugs, measure the body that sits in the lobe, not the flared edge.
  • If in doubt, ask your piercer: it’s their job.